Posts Tagged ‘hobby’
CNC Stomp Pad 6 | CNC Plasma Cutting Video Tutorial | CNC
Last video we checked our g-code to make sure our program was correct. Now we go out to the shop and do some work. We zero out the CNC Plasma Cutter and start cutting our aluminum stomp pad. Once we are done, we look it over and note the slag or dross we will have to grind off next.
http://www.cncinformation.com
Duration : 0:4:38
cnc pcb drilling
Here we are drilling a board that has been etched using MG Chemicals positive Presensitized board. CNC Router for the drill, from J.A. Bean on EBAY. Translator driver from alan at
http://www.fromorbit.com/projects/picstep/index.php
Parallel interface from http://pminmo.com/ Controller software from:
http://www.machsupport.com/artsoft/index/index.htm
Circuit board CAD from ABACOM at
http://www.abacom-online.de
Duration : 0:3:33
Posted in CNC Router Controller | 
Tags: cnc, diy, drilling, Electronics, hobby, micro, mill, PCB, PIC, router | 
13 Comments »
CNC Wood Router using NEMA 17 steppers
Size 17 stepper motors on a table top router with an AXI Outrigger motor for the spindle drive. All running with a Xylotex 3 axis drive board. The motor is powered by a PC power supply at 6 amps and 12 volts. The Xylotex drives are powered by a toroidal transformer at 28 volts. The X axis lacked a bit of power as it was so I geared it down about 3:1 and now it works a whole lot better and I have isolated the spindle motor so it now uses a toothed belt to drive the spindle just a little bit faster, about 10K revs. Still 10K revs too low for a 1/8 milling cutter.
Duration : 0:2:44
Posted in CNC Stepper Controller |
Tags: BrokenHill, cnc, Cutting, diy, engraving, hobby, homebuilt, Homemade, laser, lasing, selfbuilt |
2 Comments »
CNC Stomp 1 – CNC Project Introduction – Learn CNC Cutting
CNC Project that is shot in a tutorial sequence. It goes from the Design, CAD, CAM, Control, CNC Plasma Cutting and then final assembly. Check out this CNC How-To.
http://www.cncinformation.com
Duration : 0:3:36
CNC Stomp Pad 5 – Mach 3 G-Code – Learn CNC Plasma Cutting
In this video we go through Mach 3 to look over the g-code. We are checking to see if we have any problems before we go to the CNC Plasma Cutter.
http://www.cncinformation.com
Duration : 0:5:45
Stepper Motor In Action
This Z-Axis Slide from Athreo CNC Technology is being moved by a HobbyCNC stepper driver kit with a 3V 3A Stepper motor. http://www.athreocnc.com/
Duration : 0:0:25
CNC home shop mill retrofit
RF-31 CNC Mill (originally CNC Jr.) retrofitted with Mach3 and CandCNC coontrols. test cuts and engraving
Duration : 0:4:33
CNC home shop mill retrofit
RF-31 CNC Mill (originally CNC Jr.) retrofitted with Mach3 and CandCNC coontrols. test cuts and engraving
Duration : 0:4:33
